Replacing A Type A Electrical Lifter Column - Invacare Storm4 Series Service Manual

®
Invacare - STORM

8.15.2.2 Replacing a type A electrical lifter column

WARNING: Danger of crushing!
The seat is very heavy. Injury hazard to hands and feet!
· Use proper lifting techniques.
WARNING: Danger of crushing!
The mobility device is very heavy. Injury hazard to hands and feet!
· Use proper lifting techniques.
Injury hazard caused by uncontrolled movement of the mobility device!
· Switch the power supply off (ON/OFF key).
· Engage the drive.
· Position the mobility device on it's side and secure the position so it does not turn over.
Requirements:
· 4 mm Allen key
· T40 torx wrench
· Oblique pliers
· Cable ties
Dismantling the lifting column:
·
Remove the rear battery compartment cover as described in chapter 8.1.1.
·
Remove the centre battery compartment cover as described in chapter 8.1.2.
·
Remove the front battery compartment cover as described in chapter 8.1.3.
·
Remove the seat as described in chapter 8.15.1.1 or 8.15.1.3 respectively.
·
Disconnect the cable of the lifter column from the actuator module on the battery box.
·
Open the cable clamps and expose the cable.
4 ®
Series SERVICE MANUAL
157