8.1.3
Opening the front panel
Requirements:
• 4 mm Allen key
Dismantling the front cover panel:
•
Use the lifter to move the seat to the uppermost position. If a lifter is not available, you have to
remove the seat as described in chapter 8.5.1 or 8.5.3 respectively.
•
Remove the rear and centre cover as described in chapters 8.1.1 and Fehler! Verweisquelle
konnte nicht gefunden werden..
•
Loosen the two Allen screws (1) – concealed by the motor in the picture – using a 4 mm Allen
key.
•
Pull the motor cable and the guide bushes (2) out of the lateral recesses.
•
Pull the connecting cable to the seat out of the recess (3).
•
Lift off the front cover to the rear.
Refitting the front panel:
•
Refit the parts in reverse order.
•
Now tighten all the screws finger-tight again.
33