Replacing The Front Suspension Strut (Only Storm X-Plore) - Invacare Storm4 Series Service Manual

®
Invacare - STORM
8.14.3 Replacing the front suspension strut (only Storm
Note
Invacare® always recommends that you replace both suspension struts to ensure perfect mobility
device operation.
The springs in the wheel suspension can be selected in two weight classes depending on the
weight of the user.
The different weight classes are labelled using coloured dots on the spring.
1 dot: up to kg user weight
4 dots over kg user weight
WARNING: Danger of crushing!
The mobility device is very heavy. Injury hazard to hands and feet!
· Use proper lifting techniques:
Injury hazard caused by uncontrolled movement of the mobility device!
· Switch the power supply off (ON/OFF key).
· Engage the drive.
· Before raising the vehicle, secure the wheels by blocking them with wedges.
Requirements:
· long wooden blocks, min. 14 x 14 x 30 cm
Dismantling the suspension strut:
·
Lift the mobility device onto several wooden blocks. Use proper lifting techniques
·
Remove the securing clip (3).
·
Remove the spacer (2).
·
Carefully remove the bolts (5) which connect the shock absorber (4) to the swing arm (1).
·
Repeat this procedure for the rear bolts
·
Remove the suspension strut.
4 ®
Series SERVICE MANUAL
4
X-plore)
147