SERVICE MANUAL
8.12.1.1 Disassembling the tyre and rim on a vehicle with pneumatic tyres
ATTENTION: Explosion hazard!
If the wheelchair is fitted with pneumatic tyres, the wheel can explode if the air is
not released from the tyre before removing the wheel!
· Always release the air from the wheel before you remove it. Depress the small
tappet in the centre of the valve!
●
Unscrew valve cap.
●
Depressurise tyre by pressing in the
pin in the valve (1).
●
Unscrew 5 screws (2) using the
6mm Allen key.
●
Remove the wheel rim half with the
inner tube.
8.12.1.2 Disassembling the rim and the tyre on a vehicle with puncture-proof tyres
WARNING!
Danger of damage to the motor if the screws are not loosened and removed in the
correct sequence!
· Make sure you loosen and remove the screws in the correct sequence!
Screws 1 to 5 must be loosened and
removed in a particular sequence in
relation to each other. There is no pre-
defined numbering for the screws. There
is, for example, no screw with the pre-
defined number "1". For this reason, you
can start with any screw. This will then be
"number 1". "Number 2" is then the screw
next to it in a clockwise direction, "3" is
the next and so on.
●
Loosen and remove screws 1 and 3,
using the 6mm Allen key.
●
Loosen screws 2, 4 and 5 a single
turn each, one after the other, going
from screw to screw in a clockwise
direction, until they have all been
completely loosened and removed.
●
Remove the rim-half and the
puncture-proof inlay from the wheel.
132
®
Invacare
- STORM
4 ®
Series