Konica Minolta bizhub C650 Service Manual page 586

Field Service Ver. 8.0 Jun. 2008
J. Conversion Up
• For bizhub C550/C451, this is displayed only when the function enhanced version 1 or
later firmware is installed.
Functions • To convert and update management information data so that they become compati-
ble with the enhanced version of firmware.
Use • In the process of firmware upgrade to the function enhanced version 1 or 2 firmware,
use this function after rewriting the firmware.
Adjustment 1. Call the Service Mode to the screen.
2. Touch [State Confirmation] → [Memory /HDD Adj.] → [Conversion Up].
Procedure
3. Check to see that the Start key is lit in blue. Touch the Start key to initiate Conversion
Up.
4. When Conversion Up is completed, the result is displayed on the screen.
NOTE
• Make sure to turn off the main power switch when Conversion Up is complete,
and turn it on again more than 10 seconds after.
K. HDD R/W Check
Functions • To check to see if the hard disk is connected properly, and if read/write operation of
the hard disk is correctly performed.
Use • When the hard disk is mounted.
Adjustment 1. Call the Service Mode to the screen.
2. Touch these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [HDD
Procedure
R/W Check].
3. Pressing the Start key will start the hard disk R/W check sequence and be termi-
nated automatically.
4. The check result will be displayed, [OK] or [NG].
L. HDD Format
Functions • To format the hard disk.
• The function proceeds in the order of physical format to logical format.
• If the hard disk is yet to be formatted, the malfunction code "C-D010" will appear.
Ignore this code and continue with the formatting procedure.
Use • When the hard disk is mounted.
• When the hard disk is to be initialized. (Physical format to logical format)
Adjustment 1. Call the Service Mode to the screen.
2. Touch these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [HDD
Procedure
Format].
(1) Physical Format
1. Touch [Physical Format].
2. Press the Start key to start the formatting sequence.
3. The sequence will be automatically terminated as it is completed.
4. Turn off the main power switch and turn it on again more than 10 seconds after.
(2) Logical Format (only when initial is set up)
1. Touch [Logical Format].
2. Press the Start key to start the formatting sequence.
3. The sequence will be automatically terminated as it is completed.
4. Turn off the main power switch and turn it on again more than 10 seconds after.
✽ Formatting the hard disk will erase all data contained in it.
10. Service Mode
533