Konica Minolta bizhub C650 Service Manual page 185

6. Other
[3]
[2]
B. Reinstall procedure
NOTE
• When replacing the original glass moving unit, clean the glass surface of the orig-
inal glass moving unit.
Clean the inside of the glass well since it cannot be easily cleaned once it is
mounted.
1. When mounting the new original glass moving unit, take out the original glass moving
unit cover.
[1]
[2]
132
8. Disconnect the connector [1].
[1]
A00JF2C418DA
9. Remove four screws [1], and remove
[1]
NOTE
• Use care not to lose the spacer [3]
• Write down the type and numbers
[3]
A00JF2C419DA
2. Set the spacers [1] and mount the
NOTE
• Make sure to set the spacers [1]
[1]
A00JF2C420DA
Field Service Ver. 8.0 Jun. 2008
the original glass moving unit [2].
mounted on each screw.
of the spacer [3].
The same numbers of the spacer of
the same type with what is written
should be mounted when replacing
the original glass moving unit.
original glass moving unit [2] to the
machine.
which are exact same type and
number as before removing the
original glass moving unit.