Konica Minolta bizhub C650 Service Manual page 364

Field Service Ver. 8.0 Jun. 2008
D. Default Scan/Fax Settings
• This menu is unavailable if user authentication is not made while either of authentication
devices is set to set in the [Service Mode] → [Billing Setting] → [Management Function
Choice].
• This menu is not available when the key counter is set or when a warning appears to
inform that the vendor's main power switch needs to be checked or coins (a card) are not
inserted under the condition where the vendor is set to Set in the [Service Mode] → [Bill-
ing Setting] → [Management Function Choice].
Functions • To make default settings for the fax/scan mode.
* The machine is initialized at the following timings:
• The main power switch is turned ON.
• Panel is reset.
• In an Interrupt mode.
• Auto Reset
• The password entry screen for account track is changed.
Use • To change the Initial mode setting to meet the user's need.
Setting/ <Current Setting>
Procedure • The settings made on the control panel before entering the setting menu screens are
registered as the default settings of fax/scan functions.
<Factory Default>
• The settings made at the time of shipment from the factory are registered as the
default settings of fax/scan functions.
E. Default Enlarge Display Settings
3
• This is displayed only when the function enhanced version 2 or later firmware is installed.
• Displayed only when you select [Utility/Counter] → [User Settings] → [Scan/Fax Settings]
in the enlarge display mode.
Functions • To make default settings for the enlarge display mode.
* The machine is initialized at the following timings:
• The main power switch is turned ON.
• Panel is reset.
• In an Interrupt mode.
• Auto Reset
• The password entry screen for account track is changed.
Use • To change the Initial mode setting to meet the user's need.
Setting/ <Current Setting>
Procedure • The settings made on the control panel before entering the setting menu screens are
registered as the default settings of fax/scan functions.
<Factory Default>
• The settings made at the time of shipment from the factory are registered as the
default settings of fax/scan functions.
8. Utility Mode
311
3