Konica Minolta bizhub C650 Service Manual page 448

Field Service Ver. 8.0 Jun. 2008
<NTP Server Setting>
Functions • To set the NTP server address.
Use • To enter the NTP server address.
Setting/ <Host Address>
Procedure 1. Touch [Host Address].
2. Select [IP Address Input], and enter the IP address.
3. Select [Host name Input], and enter the host name.
<Port Number>
1. Touch the Clear key.
2. Enter the port number between 1 and 65535 using the 10-key pad.
(3) Status Notification Setting
• It will not be displayed when the following setting shows that authentication device is
mounted.
[Service Mode] → [Billing Setting] → [Management Function Choice]
• To notify status, notifications both by E-mail and by SNMP TRAP function can be set. For
E-mail, up to ten IP addresses and one IPX address can be set. For SNMP TRAP func-
tion, up to five IP addresses and one IPX can be set.
<Register Notification Address (IP Address)>
Functions • To set IP addresses to which machine status notifications are sent.
Use • Use this function when setting IP addresses to which machine status notifications are
sent.
• Up to 5 addresses can be registered.
Setting/ 1. From IP address 1 to 5, select an IP address where settings are made.
Procedure 2. Touch [Host Address].
3. Select [Input Host], [IPv4 Address Input] or [IPv6 Address Input] and enter a host
address.
4. Touch the Clear key and enter a port number within the range of 1 to 65535 using the
10-key pad.
5. Touch [Community Name] and enter a community name.
6. Touch [Notification Item] and set the items to be notified to [ON].
7. Touch [OK] and finish the settings.
<Register Notification Address (IPX Address)>
Functions • To set IPX addresses to which machine status notifications are sent.
Use • Use this function when setting IPX addresses to which machine status notifications
are sent.
Setting/ 1. Touch [IPX Address].
Procedure 2. Touch [Network Address] or [Node Address] and enter an address.
3. Touch [Community Name] and enter a community name.
4. Touch [Notification Item] and set the items to be notified to [ON].
5. Touch [OK] and finish the settings.
8. Utility Mode
395