Field Service Ver. 8.0 Jun. 2008
6.4
Cleaning procedure
NOTE
• The alcohol described in the cleaning procedure represents the ethanol isopropyl
1
alcohol.
6.4.1
Transfer belt unit
1. Remove the transfer belt unit.
See P.55
1
[1]
6.4.2
Tray 1 feed roller/tray 1 pick-up roller
1. Open the manual bypass tray door.
2. Remove the tray 1 separation roller assy.
See the steps 1 to 2 of tray 1 separation roller assy replacement procedure.
See P.34
3. Slide out the tray 1.
[1]
2. Using a dried soft cloth, wipe the
transfer belt [1].
NOTE
• If it is difficult to clean with dried
soft cloth, dampen a soft cloth with
a solvent.
• Do not wipe out with water.
• When solvent is used to dampen a
cloth, do not use the ones other
than shown below:
Isopropyl alcohol
• After cleaned with the solvent,
A00JF2C371DA
make copies more than 28-piece of
A3 white paper to eliminate the
image noise.
4. Using a soft cloth dampened with
alcohol, wipe the tray 1 feed roller [1]
clean of dirt.
A00JF2C372DA
6. Other
261
1