Change Warm Up Time *Bizhub C451 Only; Machine State Led Setting - Konica Minolta bizhub C650 Service Manual

10. Service Mode
10.8.13

Change Warm Up Time *bizhub C451 only

• This function is only for Taiwan.
Functions • To change the warm up time to be spent before the start of monochrome printing.
Use • When a paper curl problem occurs in monochrome printing immediately after the
Setting/ • The default setting is Mode 1.
Procedure
10.8.14

Machine State LED Setting

• For bizhub C550/C451, this is displayed only when the function enhanced version 1 or
later firmware is installed.
Functions • To set how to display main body statuses on the machine state LED (state display
Use
• Each of Type1 and Type2 has the following LED display forms.
Warning statuses
Amount of paper
remaining
(Tray 1 and 2)
Amount of paper
remaining
(Tray 3 and 4, LCT)
Setting/ • Each default setting is Type1.
Procedure
NOTE
4 • [Type 2] is the default setting, if the firmware of function enhanced version 3 or
494
4
completion of warm up operation under Mode 1 selection (30 seconds for mono-
chrome prints), the mode selection needs to be changed into Mode 2 (60 seconds for
monochrome prints).
Mode 1: Default, 30 seconds of warm up time for monochrome printing
Mode 2: 60 seconds of warm up time for monochrome printing
"Mode 1"
lamp, paper empty lamp).
Machine State LED Setting
Attention
• Toner supply door open
• Improper toner cartridge placement
Near life
Alert code
Trouble isolation
Fatal error
• Trouble code
• Jam
• Door opened
• Life stop
100 % to near empty
Near empty
Empty
Being lifted up
Door opened or closed
100 % to near empty
Near empty
Empty
Being lifted up
Door opened or closed
"Type 1"
later is mounted.
Field Service Ver. 8.0 Jun. 2008
Mode 2
Type1
Blinking
Blinking
Unlit
Blinking
Lit
Unlit
Blinking
Lit
Unlit
Unlit
Blinking
Lit
Unlit
Type 2
Type2
Blinking
Unlit
Unlit
Blinking
Lit
Unlit
Unlit
Lit
Unlit
Unlit
Unlit
Lit
Unlit