Punch Unit Hor. Position; Punch Unit Edge Detection - Konica Minolta bizhub C650 Service Manual

Field Service Ver. 2.0 May 2008
5.1.2

Punch Unit Hor. Position

• To adjust the position of the punch hole in the main scanning direction when ZU is in
Functions
use.
Use • Make the adjustment upon setup of ZU-603.
• Make copies in the punch mode and adjust so that width B falls within the range of the
following specifications.
Adjustment
Specification
• Standard value: B = 10.5 mm
• Setting range: -10.0 mm to +10.0 mm (Step = 0.1 mm)
Adjustment • To make width B greater: Enter the Value of [+]
Instructions • To make width B smaller: Enter the Value of [-]
1. Call the Service Mode to the screen.
See P.434 of the main body service manual.
2. Touch [Finisher] → [FS-FN adjustment].
3. Touch [Punch Unit Hor. Position].
4. Make the setting using [+] or [-].
Setting/
5. Touch [OK] twice.
Procedure
6. Touch [Exit] on the Service Mode screen.
7. Turn OFF the main power switch. then, wait for 10 sec. or more and turn ON the main
power switch.
8. Make copies in the punch mode again and check that the punch hole positions have
been adjusted properly.
5.1.3

Punch unit edge detection

• To adjust sensitivity (intensity) of the paper size detect board (PSDTB) of the punch
Functions
unit of ZU.
Use • Make the adjustment upon setup of ZU-603.
1. Call the Service Mode to the screen.
See P.434 of the main body service manual.
2. Touch [Finisher] → [FS-FN adjustment].
3. Touch [Punch unit edge detection].
4. Press the start key.
5. Check whether the result is [OK].
Setting/
NOTE
Procedure
• If the [NG] appears, check the install condition again.
6. Touch [OK] twice.
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch. then, wait for 10 sec. or more and turn ON the main
power switch.
B B
5. Finisher
B
A07TF3E514DA
33