Enable Dhcp For All Member Interfaces Of A Vlan - NETGEAR GS108Tv3 User Manual

8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
7. Select the DHCP Snooping Mode Enable radio button.
The default is Disable.
8. To enable the verification of the sender's MAC address for DHCP snooping, leave the MAC
Address Validation Enable radio button selected.
The default is Enable.
When MAC address validation is enabled, the device checks packets that are received on
an untrusted interface to verify that the MAC address and the DHCP client hardware
address match. If the addresses do not match, the device drops the packet.
9. Click the Apply button.
Your settings are saved.

Enable DHCP for all member interfaces of a VLAN

To enable DHCP snooping for all member interfaces of a VLAN:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the switch on-network and
connected to the Internet on page 19 or Access the switch off-network on page 30.
The login page displays.
If the NETGEAR Business page displays, see Register and access the switch with your
NETGEAR account on page 34.
Configure System Information
Cloud Management
124 User Manual