Repeat Redial; Pulse-To-Tone Switchover - STARPLUS Triad 1 Product Description Manual

5-52
Chapter 5 - Electronic Telephone Operation
Message Access (with a desired message) may be assigned to a flex button.
Messages may be entered while off-hook on a call if an intercom call has camped-on to
the station. This causes the station calling to see the message.
Messages are retained in battery protected area of memory in the event of power failure
or system reset.

Pulse-To-Tone Switchover

The signaling on an outside line can be changed from dial pulse to tone (DTMF) manually
while dialing out.
Performing the Change-Over
Dial an [
The Pulse-To-Tone Switchover command may also be included into a speed dial bin. Refer to
"Storing Speed Numbers"

Repeat Redial

The Repeat Redial feature allows an electronic key telephone to redial a busy or no-answer
number at specific intervals. The user is signaled via a queue callback indication. The Redial
flexible button flashes at the callback rate of 120 ipm for 15 seconds.
If station doesn't answer within the 15 seconds, the callback is cancelled. The system
retains the last call the user made.
If station is busy when the Redial queue callback occurs, the callback does not take place
until the user goes on-hook.
The user must enter a Redial timer value when invoking this feature. This value is from
006-999 which represents seconds. A 2-minute interval is entered as 120. Default value is
1 minute (60).
Placing a CO Call (when Busy or No Answer received)
1. Press the preprogrammed Redial flexible button. The LCD prompts the user for a timer
value.
2. Enter a valid number (006-999 seconds) for the Repeat Redial timer. Default value is
1 minute (60). A confirmation tone sounds and the station user goes on-hook. The
flexible button LED light solid.
When the timer expires, the station is signaled via a CO line queue indication on the
Repeat Redial flexible button. During the queue callback, the LCD display indicates that
this is a Redial Callback.
] on the dial pad. The remaining digit(s) are sent using DTMF.
.
in this chapter for Speed Dial programming.
E N TE R R PT R E D IA L TI M E R :
X X X
Pulse-To-Tone Switchover
006 -9 99