Automatic Busy Redial; Automatic Line Selection - STARPLUS DHS User Manual

Features

Automatic Busy Redial

Automatic Line Selection

Description
Automatic Busy Redial (ABR) may be used to redial the
last number. The system will automatically dials the
number and then monitors the line for a busy signal. If
a busy signal is detected, the system ends the call and
attempts to dial the number again. The redial cycle
will continue until the maximum number of attempts
designated in programming is reached.
Operation
1. Press [FEAT]
2. Dial [7] + [8]. An Executive Telephone will display:
CO LI N E X
- - >1/10
The system will continue redial attempts until busy
tone is no longer detected, or the maximum number
of attempts is reached, or any other feature is used on
the telephone.
ABR requires the Option Module on the DHS for
operation.
Description
This feature allows you to access a specific outside line
or intercom (ICM) automatically when you lift the
handset or press [SPKR].
A line will not be accessed automatically when your
telephone is receiving an incoming call (outside or
intercom) or a line is recalling at your telephone.
However, you may override this incoming call priority
operation by pre-selecting an outgoing line before
lifting the handset.
25