STARPLUS Triad 1 Product Description Manual page 226

6-48
Chapter 6 - Digital Station Operation
CKTU -- This mode is used when the optional Wanderer (cordless key telephone unit) is
connected to the station. (Refer to the Wanderer User Guide for additional information.)
SPI -- Service Provider Interface. This mode is used in conjunction with TAPI applications
such as Discovery Link.
TAPI -- for future use.
At an idle station:
1. Dial the Keyset Mode code [648] on the dial pad,
-or-
Press preprogrammed KEYSET MODE button, the following displays:
2. Press [
3. Press [#] to scroll through the baud rates.
4. Press the HOLD button to save the desired entries.
Conditions
Telephone must be in AT command mode to process AT commands.
CTI information is still sent out the RS232 port in AT command mode.
The ATD command is always accepted by the telephone while it is in the AT command
mode. ATHX is accepted only if enabled.
ATZ is always enabled if station is in the ATD or ATH command mode.
ATD accepts W to indicate a pause command (ATDT9W9982200).
ATH or ATH0 causes an on hook event. ATH1 must be specified to go off hook.
Default mode is inactive.
AT or ATZX (X = 0 or 1) is the modem reset/initialize command. When these commands
are sent to the keyset, it returns OK in ASCII format.
Keyset Self Test
The Triad 1/2/3
Digital Telephones and DSS consoles. The term off-line means that the unit under test is
disconnected from the system during the test operation. Digital Telephones not under test
continue to operate in the normal manner.
Tests are provided to verify the keyset and DSS LED, LCD, and keypad button operations.
The KSU system software version must be 1.34 or greater for Wanderer operation.
Version 1.3 can be obtained from the Sales department.
KSU system software Version 1.3 does not support DOS DBA.
On the Triad 3 system, the Firmware version must be 1.0B on Issue 1 cards (Issue
1 F/W Part Number 9022-00) or 1.0D on Issue 2 cards (Issue 2 F/W Part Number
9022-10). This firmware can be obtained from the Sales department.
I NAC TI V E
M O DE = S AV E = H O LD
.
] to scroll through the keyset modes.
.
System contains a test mode feature that supports the off-line testing of
2400
B AU D= #
Keyset Mode