Basic Rate Interface Board (Brib) - STARPLUS Triad 1 Product Description Manual

11-16
Chapter 11 - Triad 3 System Configuration

Basic Rate Interface Board (BRIB)

The BRIB allows the network connection to a Basic Rate ISDN digital interface.
The board can support TIE, Loop and Ground Start signaling emulation per channel.
The board uses the U interface of the BRI standard.
Connection to the network is made via RJ45 connectors on the front edge of the board.
No NT1 device is required to connect to the central office.
A Normal/Service switch located toward the top of the card allows the card to be inserted
or removed from the system while under power.
The BRIB card can accept up to two DTMF-A units and one BRIB-E in a daughter board
type arrangement.
The Phase Lock Loop unit (PLLU) must be installed on the MPB for the BRIB to operate
properly.
The BRIB uses eight time slots when installed.
The board does not support the trunk features of Paging, Reseize, Queuing, or RAN
Support.
The card ejector tabs are color coded white.
The BRIB can only be installed in the Basic Cabinet (BKSU) Slots 1-8. A maximum
of eight BRI boards can be installed in the system (64 B channels).
The BRI board only supports the National ISDN 1 (NI-1) standards.
Vodavi has successfully integrated its BRI ISDN with the Lucent 5 ESS Central
Office. Vodavi ISDN should work with all Central Office switches, but this has not
been verified. Therefore, some delays in service may be experienced.
Peripheral Boards