STARPLUS Triad 1 Product Description Manual page 225

Keyset Mode
In the P mode (LED flashes at 30 ipm), you hear three bursts of tone and one-way
announcement. The calling party cannot hear conversations in progress.
Lift the handset or press the ON/OFF button to answer,
-or-
Press the H-T-P button to the H mode to reply.
In the H mode (No LED), you hear three bursts of tone and an announcement.
Reply handsfree or lift the handset for privacy.
Intercom Transfer
Using Intercom Transfer without DSS Buttons
1. Receive or make an intercom call.
2. Press the TRANS button. Intercom dial tone sounds.
3. Dial the station.
4. When the second station answers, you are in a supervised transfer mode (first station is
staged for transfer).
5. Hang up (stations 1 and 2 are connected).
Using Intercom Transfer with DSS Buttons
1. Receive or make an intercom call using a DSS button.
2. Press the TRANS button. Intercom dial tone sounds.
3. Press the DSS button where to transfer the call.
4. Hang up (stations 1 and 2 are connected).
Keyset Mode
The Keyset Mode feature lets a station user determine the mode and baud rate of the
optional CTI Module connected to their phone. When the telephone is set to the AT
command mode, the following AT commands are supported:
Inactive -- No CTI information is sent/received by the telephone.
PC Phone -- CTI information used with VODAVI Discovery Desktop software must be set
to 4800 baud rate.
ATD -- This is the modem dialing command. The telephone recognizes the ATD and
accepts digits after the command. This allows the PC connection to the telephone to use
the AT Ringing command. (Available baud rates are: 1200, 2400, and 4800.)
ATH or ATHX (X = 0 or 1) -- The modem on hook/off hook command (ATH) forces the
telephone to the on-hook state from its current state. ATH1 forces the telephone to the
off-hook state from its current state.
If the handset is off hook (lifted), these commands are discarded and no action is
taken by the telephone.
Chapter 6 - Digital Station Operation
6-47