Ring Generator Unit (Rgu); System Configuration Tables - STARPLUS Triad 1 Product Description Manual

Ring Generator Unit (RGU)

Ring Generator Unit (RGU)
The RGU is used whenever SLT devices are installed on the system. This units supplies the
ring voltage and message wait voltage for the operation of SLT on the system. The unit is wall
mounted and connects to the BKSU. One per BKSU, EKSU1 is required for SLT operation.

System Configuration Tables

Ports
CO/PBX/Centrex Lines
DID Lines
T-1 Trunks
ISDN Trunks
Stations
Analog Stations
Digital Telephones
Single Line Telephones
DTMF Receiver
Figure 11-31: RGU (Ring Generator Unit)
Table 11-1: Digital System Capacity
112 max. (8 per LCOB/GCOB Board)
96 max. (8 per DIDB)
144 max. (24 T-1 trunk circuits per T1IB board)
138 max. (23 trunks per PRIB board)
252 max. (12 per ETIB Board)
252 max. (12/24 per DTIB Board)
180 max. (12 per SLIB Board)
26 max. (2 on MISU, 24 on peripheral boards) Each DTMF Receiver Unit
(DTMF-A or DTMF-B) contains 4 DTMF receivers. The DTMF-A board
mounts as a daughter board on the T1IB, PRIB, and SLIB Board. The DTMF-
B board mounts as a daughter board on the LCOB/GCOB, DIDB.
The dial pulse function is not available in
Chapter 11 - Triad 3 System Configuration
Triad-S systems.
11-35