STARPLUS Triad 1 Product Description Manual page 202

6-24
Chapter 6 - Digital Station Operation
4. Dial the appropriate forwarding condition code.
[6] = All Calls
[7] = No Answer
5. Dial the three- or four-digit destination number where calls are to be forwarded. Station,
Voice Mail, ACD/UCD, or Hunt Groups.)
6. Replace handset or press ON/OFF button.
Removing Follow-Me Call Forwarding
1. Lift the handset or press ON/OFF button.
2. Dial the Follow-Me Forward code [642] on the dial pad.
3. Dial the station number of the station that forwarding is to be cancelled.
4. Dial [6] (regardless of the forward condition).
5. Redial the same station number. A confirmation tone sounds and the FWD LED
extinguishes.
Establishing Follow-Me Call Forwarding (off-site location)
1. Dial into the system on a DISA or TIE trunk. Enter the DISA access code, if applicable.
2. Dial the Follow-Me Forward code [642] on the dial pad.
3. Dial the station number of the station from which forwarding is desired.
4. Dial the appropriate forwarding condition code.
[6] = All Calls
[7] = No Answer
5. Dial the three- or four-digit destination number where calls are to be forwarded. Station,
Voice Mail, ACD/UCD or Hunt Groups.) A confirmation tone sounds; five seconds later a
dial tone is received.
Removing Follow-Me Call Forwarding (off-site location)
1. Dial into the system on a DISA or TIE trunk. Enter the DISA access code, if applicable.
2. Dial the Follow-Me Forward code [642] on the dial pad.
3. Dial the station number of the station that forwarding is to be cancelled.
4. Dial [6] (regardless of the forward condition).
5. Redial the same station number. A confirmation tone sounds; five seconds later a dial
tone is received.
Conditions
If a Call Forward mode is currently active at the station where forwarding is desired, the
new forward becomes active and cancels the previous forward.
Both internal and external calls to the affected station forward to the designated location.
Call forwarding must be allowed in programming for the affected station.
When remote forward is activated, the forwarding is immediate.
A station's Call Forward status is stored in a battery protected area of memory. A station's
Call Forward status is returned after a power failure or system reset occurs.
[8] = Busy
[9] = Busy/No Answer
[8] = Busy
[9] = Busy/No Answer
Call Forward: Station