Pulse-To-Tone Switchover - STARPLUS Triad 1 Product Description Manual

Pulse-to-Tone Switchover

When a message displays by a key telephone, the DND button LED flashes at 15 ipm.
When DND is invoked on the telephone, the message cancels.
Message Access (with a desired message) may be assigned to a flexible button.
Messages may be entered while off-hook on a call if an intercom call is camped onto the
station. This causes the station calling to see the message.
Messages are retained in battery protected area of memory in the event of power failure
or system reset.
Pulse-to-Tone Switchover
Signaling on an outside line can be changed from dial pulse to tone (DTMF) manually while
dialing out.
Performing the Change-Over
Dial [ ] on the dial pad. The remaining digit(s) is sent using DTMF.
.
(The Pulse-To-Tone Switchover command may also be included in a speed dial bin.)
Repeat Redial
The Repeat Redial feature lets a digital key station redial a busy or no-answer number at
specific intervals. The user is signaled via a queue call back indication.
The REDIAL flexible button flashes at the callback rate of 120 ipm for 15 seconds. If the station
does not answer within 15 seconds, the callback cancels. The system retains the last call the
user made. If the station is busy on an internal/external call when the Redial Queue Call Back
occurs, the callback does not occur until the user goes on-hook.
The user must enter a Redial Timer value (006-999 that represents seconds) when invoking
this feature. A two minute interval is entered as 120. Default value is 1 minute (60).
A keyset station user places a CO call and receives a Busy or No Answer:
1. Press the preprogrammed REPEAT REDIAL flexible button [643]. The LCD prompts the
user for a timer value.
2. Enter a valid number (006-999 seconds) for the Repeat Redial timer. Default value is 060
(one minute). A confirmation tone sounds and the station user goes on-hook. The flexible
button LED lights steady.
When the timer expires, the station is signaled via a CO line queue indication on the
REPEAT REDIAL flexible button. During the Queue Call Back, the LCD display indicates this
is a Redial Call Back. Once line queue is answered, the LCD indicates an outgoing CO line
display.
EN TER R P T RE DI A L TI M E R :
X X X
Chapter 6 - Digital Station Operation
006 -9 99
6-61