Calibrate Humidity/Temperature For Duplex (Dfu); Set Charge Area - Ricoh BRG-P1 Field Service Manual

Calibrate Humidity/Temperature for Duplex (DFU)

1-012-001 CHG:TEMP:B
1-012-002 CHG:HUMI:B

Set Charge Area

1-012-003 CHG:AREA:EDGE:F
Use this SP to set the size of the leading and trailing edges for the 1st side of paper. Do this setting
when you want to adjust pitch amount of the charge applied to the leading and trailing edges for
printing. The areas of the leading and trailing edges is shown below.
[0 to 0xff/0/1/---]
1-012-004 CHG:AREA:EDGE:B
Use this SP to set the size of the midle area for the 1
adjust pitch amount of the charge applied to the leading and trailing edges for printing. The areas of
the leading and trailing edges is shown below.
[0 to 0xff/0/1/---]
1-012-005 CHG:AREA:MIDL:F
Use this SP to set the size of the leading and trailing edges for the 1st side of paper. Do this setting
when you want to adjust pitch amount of the charge applied to the middle area for printing. The
middle area is shown below.
[0 to 0xff/0/1/---]
1-012-006 CHG:AREA:MIDL:B
Use this SP to set the size of the leading and trailing edges for the 2nd side of paper. Do this setting
when you want to adjust pitch amount of the charge applied to the middle area for printing. The
middle area is shown below.
[0 to 0xff/0/1/---]
Calibrate Humidity Setting for Duplex
Calibrate Temperature Setting for Duplex
Set Charge of Area for LE/TE: Simplex
Set Charge of Area for LE/TE: Duplex
st
ide of paper. Do this setting when you want to
Set Charge of Area for Middle: Simplex
Set Charge of Area for Middle: Duplex
SP Mode Service Tables
45