Lexus 2005 IS300 User Manual page 827

Clamp
2005 LEXUS IS300 (RM1140U)
ENGINE MECHANICAL
22. CONNECT FRONT EXHAUST PIPE TO EXHAUST
MANIFOLD
(a) Temporarily install the pipe support bracket to the trans-
mission with the 2 bolts.
(b) Install 2 new gaskets to front end of the front exhaust pipe,
and connect the front exhaust pipe to the exhaust man-
ifold with the 3 bolts nuts and retainer.
Torque: 43 N·m (438 kgf·cm, 32 ft·lbf)
A14343
(c) Connect the wire grommet and sensor wire of the the
Wire
heated oxygen sensor (bank 2 sensor 2) to the hole and
Grommet
clamp on the floor.
B01935
23. INSTALL PS PUMP
(a) Install the vane pump with the 2 bolts.
Torque: 58 N·m (590 kgf·cm, 43 ft·lbf)
(b) Install the pump rear stay with the 2 bolts.
Torque: 39.2 N·m (400 kgf·cm, 29 ft·lbf)
(c) Connect the PS air hose to the No.4 timing belt cover.
(d) Connect the PS air hose to the air intake chamber.
24. INSTALL DRIVE BELT (See page
25. M/T:
A02802
INSTALL DRIVE BELT TENSIONER ABSORBER
Install the absorber with the 2 nuts.
Torque: 20 N·m (200 kgf·cm, 14 ft·lbf)
26. INSTALL AIR CLEANER, MAF METER AND INTAKE
AIR RESONATOR ASSEMBLY (See page
27. INSTALL AIR CLEANER INLET
28. CONNECT UPPER RADIATOR HOSE TO WATER OUT-
LET
29. INSTALL ENGINE COVER
Install the engine cover with the 4 nuts.
30. FILL WITH ENGINE COOLANT
31. START ENGINE AND CHECK FOR LEAKS
32. INSTALL ENGINE UNDER COVER
33. ROAD TEST
Check for abnormal noise, shock, slippage, correct shift points
and smooth operation.
34. RECHECK ENGINE COOLANT LEVEL
- CYLINDER HEAD
Author :
EM-59
CH-1 )
EM-71 )
Date :
1324