SR-52
Rack Teeth End
Vinyl Tape
Cylinder End Stopper
SST
2005 LEXUS IS300 (RM1140U)
STEERING
3.
INSTALL STEERING RACK
(a)
Install SST to the rack.
SST
HINT:
If necessary, scrape the burrs off the rack teeth end and bur-
nish.
(b)
Coat SST with power steering fluid.
(c)
Install the steering rack into the rack housing.
(d)
Remove the SST.
SST
SST
W02101
4.
INSTALL OIL SEAL
(a)
Coat a new oil seal lip with power steering fluid.
(b)
To prevent oil seal lip damage, wind vinyl tape on the
steering rack end, and apply power steering fluid.
(c)
Install the oil seal by pushing it into the rack housing with-
out tilting.
NOTICE:
Make sure that the oil seal is installed facing in the correct
direction.
F06306
5.
INSTALL CYLINDER END STOPPER AND SPACER
(a)
Install the spacer.
Wooden
(b)
Coat a new O-ring with power steering fluid and install it
Block
to the cylinder end stopper.
(c)
Using a wooden block and hammer, drive in the cylinder
end stopper until it is tightly installed.
NOTICE:
Be careful not to damage the O-ring.
W01692
(d)
Using SST, torque the cylinder end stopper.
SST
Torque: 59 N·m (600 kgf·cm, 44 ft·lbf)
F07514
-
POWER STEERING GEAR
09631-33010
09631-33010
09631-20090
Author :
Date :
1910