Side And Curtain Shield Airbag Sensor Assembly Removal - Lexus 2005 IS300 User Manual

RS-78
SUPPLEMENTAL RESTRAINT SYSTEM
2005 LEXUS IS300 (RM1140U)
- SIDE AND CURTAIN SHIELD AIRBAG SENSOR
ASSEMBLY
REMOVAL
NOTICE:
F
If the wiring connector of the SRS is disconnected
with the ignition switch at ON position, DTC will be re-
corded.
F
Do not open the cover or the case of the ECU and vari-
ous electrical devices unless absolutely necessary.
(If the IC terminals are touched, the IC may be de-
stroyed by static electricity.)
1. REMOVE FRONT AND REAR DOOR INSIDE SCUFF
PLATES
2. REMOVE CENTER PILLAR LOWER GARNISH
3. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Pages for reference
Sedan
Wagon
4. REMOVE SIDE AND CURTAIN SHIELD AIRBAG SEN-
SOR ASSEMBLY
(a) Disconnect the side and curtain shield airbag sensor as-
sembly connector.
NOTICE:
Disconnect the connector with the sensor assembly
installed.
(b) Remove the 3 bolts and side and curtain shield airbag
sensor assembly.
H19110
Author : Date :
RS0UF-03
See page
BO-21 1
BO-214
1994