Lexus 2005 IS300 User Manual page 1285

SA-38
B
A
B
2005 LEXUS IS300 (RM1140U)
SUSPENSION AND AXLE
6. CONNECT HEIGHT CONTROL SENSOR LINK
(a) Set the lower arm to the vehicle height.
(b) Install the sensor link to the lower arm bracket with a nut.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
NOTICE:
F
Be careful not to brake the link fixing pin until the
above operation is completed.
F
The pin can the broken after completion of the above,
however, the sensor arm rotation angle shall not ex-
F11610
ceed the range of ±70° from the standard vehicle
height.
7. CONNECT TIE ROD END TO LOWER BALL JOINT
(a) Connect the tie rod end to the lower ball joint with the nut.
Torque: 54 N·m (550 kgf·cm, 40 ft·lbf)
(b) Install a new clip.
HINT:
If the holes for the clip are not aligned, tighten the nut further up
to 60°.
8. INSTALL DISC AND BRAKE CALIPER
Install the disc, brake caliper and 2 bolts.
Torque: 118 N·m (1,200 kgf·cm, 87 ft·lbf)
9. CONNECT NO. 2 LOWER SUSPENSION ARM TO
NO. 1 LOWER SUSPENSION ARM
Torque: 245 N·m (2,500 kgf·cm, 181 ft·lbf)
HINT:
After stabilizing the suspension, torque the bolt.
10. INSTALL FRONT SUSPENSION MEMBER BRACE
Torque:
Bolt A: 119 N·m (1,210 kgf·cm, 88 ft·lbf)
Bolt B: 58 N·m (590 kgf·cm, 43 ft·lbf)
HINT:
F
Install the bolt A through the No.2 lower suspension arm.
F
After stabilizing the suspension, torque the bolt A.
11. INSTALL RH AND LH REAR ENGINE UNDER COVER
12. INSTALL ENGINE UNDER COVER AND ENGINE UN-
A
B
F07657
DER COVER NO. 2
13. INSTALL FRONT WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
14. DEPRESS BRAKE PEDAL SEVERAL TIMES
15. CHECK FRONT WHEEL ALIGNMENT
(See page
- FRONT LOWER SUSPENSION ARM
SA-5 )
Author : Date :
1707