Lexus 2005 IS300 User Manual page 1022

Pull
2005 LEXUS IS300 (RM1140U)
SFI
(3)
(4)
B02077
(g) Observe these precautions when handling nylon tube.
(1)
(2)
(3)
(4)
(h) Check that there are no fuel leaks after doing mainte-
nance anywhere on the fuel system.
Hand- held
(1)
Tester
(2)
(3)
NOTICE:
Do not start the engine.
D09381
(4)
(5)
(6)
(7)
(8)
(9)
NOTICE:
Keep cranking the engine until the air is removed from the
fuel line.
(10) After the engine starts, check again that there are
- SFI SYSTEM
After having finished the connection, check if the
pipe and the connector are securely connected by
pulling them.
Check if there is any fuel leakage.
Pay attention not to turn the connected part of the
nylon tube and quick connector with force when
connecting them.
Pay attention not to kink the nylon tube.
Do not remove the EPDM protector on the outside
of the nylon tube.
Must not close the piping with the nylon tube by
bending it.
Connect a hand-held tester to the DLC3.
Connect the hand-held tester to the DLC3.
Select the following menu items: DIAGNOSIS / EN-
HANCED OBD ll / ACTIVE TEST / FUEL PUMP /
SPD.
Please refer to the hand-held tester operator's
manual for further details.
If you have no hand-held tester, connect the posi-
tive (+) and negative (-) leads from the battery to the
fuel pump connector (See page
Check that there are no leaks from any part of the
fuel system.
Turn the ignition switch OFF.
Disconnect the hand-held tester from the DLC3.
Start the engine.
no fuel leaks.
Author :
SF-5
SF-6 ).
Date :
1386