Side Airbag Assembly Installation - Lexus 2005 IS300 User Manual

RS-52
SUPPLEMENTAL RESTRAINT SYSTEM
2005 LEXUS IS300 (RM1140U)
- SIDE AIRBAG ASSEMBLY
INSTALLATION
NOTICE:
Never use airbag parts from another vehicle. When replac-
ing parts, replace them with new parts.
1. INSTALL SEATBACK ASSEMBLY
(a) Temporarily install the seatback assembly.
(b) Set the wire harness of the side airbag assembly to the
LH reclining adjuster inside cover, as shown.
(c) Install the LH reclining adjuster inside cover set screw.
H08468
(d) Install the 4 bolts.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
NOTICE:
F
Make sure that the seatback assembly is installed
with the specified torque.
F
If the seatback assembly has been dropped, or there
are cracks, dents or other defects in the case or con-
nector, replace the seatback assembly with a new
one.
H08469
F
When installing the seatback assembly, take care it is
not pinched between other parts.
(e) Install 3 new hog rings, as shown in the illustration.
HINT:
When installing the hog rings, take care to prevent wrinkles as
much as possible.
H08470
Author : Date :
RS0E5-03
1968