Round End
2005 LEXUS IS300 (RM1140U)
STEERING
REASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1.
2.
Press
(a)
SST
(b)
Bearing
NOTICE:
Oil Seal
Be careful not to damage the oil seal.
Front Housing
(c)
Vinyl Tape
W01281
3.
Using a plastic hammer, tap in 2 new straight pins to the front
housing.
NOTICE:
Be careful not to damage the straight pins.
4.
Inscribed Mark
Install the cam ring with the inscribed mark facing outward.
HINT:
Align the holes of the cam ring with the 2 straight pins.
5.
F10388
6.
(a)
(b)
NOTICE:
Be careful the direction of the gasket.
7.
Align the holes of the side plate and 2 straight pins.
R01149
-
POWER STEERING VANE PUMP
COAT PARTS INDICATED BY ARROWS WITH POWER
STEERING FLUID (See page
INSTALL VANE PUMP SHAFT WITH BEARING
To prevent oil seal lip damage, wind vinyl tape on the ser-
rated part of the vane pump shaft.
Using SST, press in the vane pump shaft with the bearing.
SST
09608-04031
Using snap ring pliers, install a new snap ring to the front
housing.
INSTALL 2 STRAIGHT PINS
INSTALL CAM RING
INSTALL VANE PUMP ROTOR
INSTALL 10 VANE PLATES AND GASKET
Install the 10 vane plates with the round end facing out-
ward.
Install a new gasket on the front housing.
INSTALL SIDE PLATE
Author :
SR-35
SR1BZ-02
SR-27
)
Date :
1893