Airbag Sensor Assembly Installation - Lexus 2005 IS300 User Manual

SUPPLEMENTAL RESTRAINT SYSTEM
2005 LEXUS IS300 (RM1140U)
- AIRBAG SENSOR ASSEMBLY
INSTALLATION
NOTICE:
F
Never use SRS parts from another vehicle. When re-
placing parts, replace them with new parts.
F
Never reuse the airbag sensor assembly involved in
a collision when the airbag has deployed.
F
Never repair a sensor in order to reuse it.
HINT:
For step 3 to 10, refer to page
1. INSTALL AIRBAG SENSOR ASSEMBLY
(a) Using a torx wrench, install the airbag sensor assembly
with the 3 screws.
Torx wrench: T40 (Part No.09042-00020 or locally
manufactured tool)
Torque: 20 N·m (205 kgf·cm, 15 ft·lbf)
(b) Connect the 3 airbag sensor assembly connectors.
NOTICE:
F
Connection of the connector is done after the sensor
H08433
assembly has been installed.
F
Make sure the sensor assembly is installed with the
specified torque.
F
If the sensor assembly has been dropped, or there are
cracks, dents or other defects in the case, bracket or
connector, replace the sensor assembly with a new
one.
F
When installing the sensor assembly, take care that
the SRS wiring does not interfere with other parts and
is not pinched between other parts.
F
After installing, shake the sensor assembly to check
that there is no looseness.
2. INSTALL CONTROL POSITION INDICATOR PLATE
(a) Connect the engagement of the claw at 4 positions and
install the control position indicator plate.
(b) Connect the connector.
3. INSTALL CONSOLE BOX
4. INSTALL PARKING BRAKE HOLE COVER
5. INSTALL A/C CONTROL WITH RADIO RECEIVER AS-
SEMBLY
6. INSTALL LOWER CENTER CLUSTER FINISH PANEL
7. INSTALL CENTER CLUSTER FINISH PANEL
8. INSTALL CENTER REGISTER OPENING COVER
9. INSTALL UPPER CONSOLE PANEL
10. INSTALL FLOOR SHIFT LEVER KNOB
BO-149
Author : Date :
RS-71
RS0EZ-13
.
1987