Front Axle Bub Installation - Lexus 2005 IS300 User Manual

INSTALLATION
1. INSTALL STEERING KNUCKLE WITH AXLE HUB
(a) Temporarily install the steering knuckle to the upper suspension arm with the nut.
(b) Connect the steering knuckle to the lower ball joint with the 2 bolts.
Torque: 113 N·m (1,150 kgf·cm, 83 ft·lbf)
(c) Torque the nut on the upper side of the steering knuckle.
Torque: 65 N·m (660 kgf·cm, 50 ft·lbf)
(d) Install a new clip.
If the holes for the clip are not aligned, tighten the nut further up to 60°.
2. CONNECT ABS SPEED SENSOR TO STEERING KNUCKLE
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
3. CHECK BEARING BACKLASH AND AXLE HUB DEVIATION (See page
4. INSTALL DISC AND BRAKE CALIPER
Install the disc, brake caliper and 2 bolts.
Torque: 118 N·m (1,200 kgf·cm, 87 ft·lbf)
5. INSTALL FRONT WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
6. DEPRESS BRAKE PEDAL SEVERAL TIMES
7. CHECK FRONT WHEEL ALIGNMENT (See page
8. CHECK ABS SPEED SENSOR SIGNAL (See page
2005 LEXUS IS300 (RM1140U)
SUSPENSION AND AXLE - FRONT AXLE HUB
SA-5 )
DI-437 or DI-507
Author :
SA-12 )
)
Date :
SA-17
SA0R9-06
1686