Tilt Steering Column Inspection - Lexus 2005 IS300 User Manual

2005 LEXUS IS300 (RM1140U)
STEERING - TILT STEERING COLUMN
INSPECTION
1. INSPECT STEERING LOCK OPERATION
Check that the steering lock mechanism operates properly.
F07953
2. IF NECESSARY, REPLACE KEY CYLINDER
(a) Place the ignition key at the ACC position.
(b) Push down the stop pin with a screwdriver, and pull out
the cylinder.
(c) Install a new cylinder.
HINT:
Make sure the key is at the ACC position.
3. INSPECT IGNITION SWITCH (See page
4. IF NECESSARY, REPLACE IGNITION SWITCH
F07924
(a) Remove the 2 screws and ignition switch from the column
upper bracket.
(b) Install a new ignition switch with the 2 screws.
5. INSPECT KEY UNLOCK WARNING SWITCH
(See page
6. IF NECESSARY, REPLACE KEY UNLOCK WARNING
SWITCH
(a) Slide the key unlock waring switch out of the column up-
per bracket.
(b) Slide a new key unlock waring switch in the column upper
bracket.
7. INSPECT KEY INTERLOCK SOLENOID
(See page
8. IF NECESSARY, REPLACE KEY INTERLOCK SOLE-
NOID
(a) Remove the 2 screws and key interlock solenoid.
(b) Install a new key interlock solenoid with the 2 screws.
9. INSPECT TRANSPONDER KEY COIL
(See page
10. IF NECESSARY, REPLACE TRANSPONDER KEY
COIL
11. IF NECESSARY, REPLACE TRANSPONDER KEY AM-
PLIFIER
(a) Remove the 2 screws and transponder key amplifier.
(b) Install a new transponder key amplifier with the 2 screws.
BE-21 )
AT-18 )
BE-230 )
Author : Date :
SR-19
SR0LE-07
BE-21 )
1877