Curtain Shield Airbag Assembly Installation - Lexus 2005 IS300 User Manual

RS-66
SUPPLEMENTAL RESTRAINT SYSTEM
5
1
2
6
3
4
1
2005 LEXUS IS300 (RM1140U)
INSTALLATION
NOTICE:
Never use airbag parts removed from another vehicle.
When replacing parts, replace them with new parts.
1.
3
4
(a)
CAUTION:
Pay attention not to twist the deployment section of the cur-
tain shield airbag assembly.
NOTICE:
H19090
(b)
2.
3.
2
In order shown in the illustration, install the deployment section
of the curtain shield airbag assembly with the 4 bolts.
CAUTION:
Pay attention not to twist it.
NOTICE:
H19089
4.
- CURTAIN SHIELD AIRBAG ASSEMBLY
INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
In order shown in the illustration, install the curtain shield
airbag assembly with the 6 bolts.
Torque: 9.8 N·m (100 kgf·cm, 86 in.·lbf)
F
Make sure that the curtain shield airbag assembly is
installed with the specified torque.
F
If the curtain shield airbag assembly has been
dropped, or any cracks, dents or other defects in the
case or connector, replace the curtain shield airbag
assembly with a new one.
F
When installing the curtain shield airbag assembly,
be careful to prevent it from being pinched between
other parts.
Connect the connector of the curtain shield airbag as-
sembly.
INSTALL INSTRUMENT PANEL (See page
When inflator is installed:
INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
Torque: 9.8 N·m (100 kgf·cm, 86 in.·lbf)
F
Make sure that the curtain shield airbag assembly is
installed with the specified torque.
F
When installing the curtain shield airbag assembly,
be careful to prevent it from being pinched between
other parts.
INSTALL ROOF HEADLINING
Pages for reference
Sedan
Wagon
Author :
RS0N7-05
BO-149 )
See page
BO-160
BO-169
Date :
1982