Lexus 2005 IS300 User Manual page 1166

SR-56
Brass Bar
Matchmarks
SST
2005 LEXUS IS300 (RM1140U)
STEERING -
(c) Using a brass bar and a hammer, stake the washer.
NOTICE:
Avoid any impact on the steering rack.
(d) Employ the same manner described above to the other
side.
F07947
15. INSTALL RH AND LH RACK BOOTS, CLAMPS AND
CLIPS
(a) Ensure that the steering rack hole is not clogged with
grease.
HINT:
If the hole is clogged, the pressure inside the boot will change
after it is assembled and the steering wheel is turned.
(b) Install the boot, clip and a new clamp.
NOTICE:
F12260
Be careful not to damage or twist the boot.
(c) Tighten the clamp as shown in the illustration.
(d) Employ the same manner described above to the other
side.
F07914
16. INSTALL RH AND LH TIE ROD ENDS AND LOCK NUTS
(a) Screw the lock nut and tie rod end onto the rack end until
the matchmarks are aligned.
(b) After adjusting toe-in, torque the nut
(See page
Torque: 56 N·m (570 kgf·cm, 41 ft·lbf)
(c) Employ the same manner described above to the other
side.
F07501
17. INSTALL 2 TURN PRESSURE TUBES
Using SST, install the 2 turn pressure tubes.
Fulcrum
SST
Length
Torque: 22 N·m (220 kgf·cm, 16 ft·lbf)
HINT:
F
Use a torque wrench with a fulcrum length of 300 mm
(11.81 in.).
F
This torque value is effective in case that SST is parallel
to a torque wrench.
F12261
POWER STEERING GEAR
SA-5 ).
09023-38200
Author : Date :
1914