How To Read This Chapter - NEC NEAX 2000 IPS System Manual
Internet protocol server ccis system manual
Hide thumbs
Also See for NEAX 2000 IPS:
- Command manual (1038 pages) ,
- Installation manual (619 pages) ,
- Reference manual (421 pages)
Table of Contents
Advertisement
HOW TO READ THIS CHAPTER
This chapter explains the feature programming for each service feature about the following Abbreviations.
(1)
: 1st data
(2)
: 2nd data
: Initial data; With the system data clear command (CM00, CM01), the data with this marking is
automatically set for each command.
:
INITIAL
AP00 INITIAL
:
DTI INITIAL
:
OFF LINE
:
AP OFF LINE
:
A reset of the MP card is required after data setting.
Press SW1 switch on the MP card.
A reset of the AP00 card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
A reset of the DTI card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
Command with this marking can be used only under Off-Line mode of the MP
card.
To set Off-Line mode,
(1) Set SW3 on the MP card to "2" or "3".
(2) Press SW1 on the MP card.
Command with this marking can be used only under Off-Line mode of the AP00
card.
CHAPTER 3 SYSTEM DATA PROGRAMMING
– 90 –
HOW TO READ THIS CHAPTER
NWA-008853-001 Rev.3.0
97ch3001.fm
Advertisement
Table of Contents
