NEC NEAX 2000 IPS System Manual page 112

A
CMAA Assign the necessary functions to each 24DTI/
24CCT cards.
After entering the data, set the MB switch on
the DTI card to UP, and then to DOWN, for
DTI initialization.
NOTE 1: This command is only applicable for
the 24DTI/24CCT card.
NOTE 2: The following table shows the rela-
tionship between CMAA Y=01 and
Y=02.
CMAA Y=01
(FRAME
CONFIGURATION)
24-Multi Frame
[1]
12-Multi Frame
[0]
[ ] indicates 2nd Data
NOTE 3:
If 56K CCIS is used, 24 Multi-
Frame (ESF) must be assigned.
B
DESCRIPTION
DTI INITIAL
CMAA Y=02
(ZERO CODE SIGNALING
SUPPRESSION)
B8ZS
Not available
Transparent
[1]
Available
[0]
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=00 Data Mode
(1) 04-15, 20-31: AP No. assigned by CM05
0: Based on AT&T Specifications
(2)
• Y=01 Frame Configuration
(1) 04-15, 20-31: AP No. assigned by CM05
0 : 12-Multi Frame (D4)
(2)
1 : 24-Multi Frame (ESF)
• Y=02 Zero Code Suppression [B7]
(1) 04-15, 20-31: AP No. assigned by CM05
0 : Available (Non Transparent)
(2)
1 : Not available (Transparent)
• Y=03
(1) 04-15, 20-31: AP No. assigned by CM05
7 : Common Channel Interoffice Signal-
(2)
ing
B7
– 98 –
DIGITAL CCIS PROGRAMMING
DATA
Y=0
Y=0
NOTE 3
Y=0
Y=0
NWA-008853-001 Rev.3.0
97ch3001.fm