Dial Access To Attendant-Ccis - NEC NEAX 2000 IPS System Manual

DIAL ACCESS TO ATTENDANT-CCIS

General Description
This feature allows a station user to call an Attendant Console by dialing an operator call code through
the CCIS network.
Programming
START
CM62 Specify the tenants to be handled by each AT-
TCON Group.
NOTE:
CM20 Assign the digit 0 as an access code, to LCR
Group 3 (A129).
CM8A Assign an area code table to be used to select a
route pattern table.
Assign the digit 0 into the selected area code
table.
Assign the next Route Pattern number to the
Route Pattern number assigned by CM8A
Y=4005-4007.
NOTE:
A
DESCRIPTION
When marking a link with the 2400
IPX Tenant number should be as-
signed as 01-63, not 00.
This data is required to expand the
order of LCR selection that is as-
signed by CM8A Y=0000-0255.
The order of LCR selection can be
expand to the maximum seventh.
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=0-3: ATTCON Group 0-3 assigned by
(1) 00-63: Tenant No.
INITIAL
(2) 0 : To handle
1 : Not handled
• Y=0: Number Plan Group 0-3
(1) 0: Access Code
(2) A129
• Y=A000
(1) 0-3: LCR Group 0-3
(2) 4005-4007: Area Code Development Pat-
• Y=4005-4007
(1) 0
(2) 0000-0255: Route Pattern No. 000-255
• Y=0000-0255 Route Pattern No.000-255
(1) 0: Designation of next table
(2) 0000-0255: Next Route Pattern No.000-
– 262 –
DIAL ACCESS TO ATTENDANT-CCIS
DATA
CM60 Y=00
tern No. 5-7
255
NWA-008853-001 Rev.3.0
97ch3004.fm