Attendant Console - NEC NEAX 2000 IPS System Manual

Operating Procedure
Single Line Telephone
To set a Call Forwarding-All Calls-CCIS from a Single Line Telephone:
1. Lift the handset and receive dial tone.
2. Dial the Call Forwarding-All Calls feature access code and receive Feature Dial Tone.
3. Dial the outgoing trunk access code and receive a single burst of Service Set Tone.
(This operation is required for a network using Open Numbering Plan.)
4. Dial the desired target station number and receive Service Set Tone.
5. Wait approximately five seconds and receive Service Set Tone.
To cancel a Call Forwarding-All Calls-CCIS from a Single Line Telephone:
1. Lift the handset and receive dial tone.
2. Dial the Call Forwarding-All Calls cancellation code and receive Service Set Tone.

Attendant Console

To set a Call Forwarding-All Calls-CCIS from an Attendant Console:
1. Press an idle LOOP key.
2. Dial the Call Forwarding-All Calls feature access code and receive Feature Dial Tone.
3. Dial the originating station number.
4. Dial the outgoing trunk access code and receive a single burst of Service Set Tone.
(This operation is required for a network using Open Numbering Plan.)
5. Dial the desired target station number and receive Service Set Tone.
6. Press the RELEASE key.
To cancel a Call Forwarding-All Calls-CCIS from an Attendant Console:
1. Press an idle LOOP key.
2. Dial the Call Forwarding-All Calls cancellation code and receive Feature Dial Tone.
3. Dial the originating station number and receive Service Set Tone.
4. Press the RELEASE key.
NOTE: The Attendant Console can set/cancel Call Forwarding-All Calls for stations within the local
system in which the Attendant Console resides.
CALL FORWARDING-ALL CALLS-CCIS/MULTIPLE CALL FORWARDING-ALL CALLS-CCIS
– 156 –
CHAPTER 3 SYSTEM DATA PROGRAMMING
NWA-008853-001 Rev.3.0
97ch3002.fm
JANUARY/31/2006