How To Read This Chapter - NEC NEAX2000 IPS System Manual

CÔNG TY VIỄN THÔNG VIỆT PRO

HOW TO READ THIS CHAPTER

In the programming procedure, the meanings of (1), (2) and markings are as follows.
(1) : 1st Data
(2) : 2nd Data
: Initial Data
With the system data clear command (CM00, CM01), the data with this marking is
automatically assigned for each command.
INITIAL
: A reset of the MP card is required after data setting.
Press SW1 switch on the MP card.
IP-PAD INITIAL
: A reset of the IP-PAD card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
IPT INITIAL
: A reset of the IPT card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
OFF LINE
: Command with this marking can be used only under Off-Line mode of the MP card.
To set Off-Line mode,
(1) Set SW3 on the MP card to "2" or "3".
(2) Press SW1 on the MP card.
CHAPTER 3 SYSTEM DATA PROGRAMMING
Chuyên phân phối tổng đài NEC
– 78 –
http://vietpro.com.vn
HOW TO READ THIS CHAPTER
ND-71503(E) Rev.5.0
9pch3001.fm
FEBRUARY/28/2002