NEC NEAX 2000 IPS System Manual page 280

• When no release signal arrives on the IC trunk.
START
CM08 Provide the DIT-Outside feature. (In case of no
release signal on IC trunk.)
CM30 Assign the data for terminating system in Day
Mode, Night Mode, Mode A and Mode B for
the trunk, respectively.
Assign the Abbreviated Code for System
Speed Dialing to terminate to the other system
via CCIS by DIT in Day Mode and Night
Mode, Mode A and Mode B respectively.
CM35 Assign trunk route data to the trunk route num-
ber (for IC route).
A
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
(1) 324: DIT-Outside
(2) 0: Allow
(When both answer and release signal ap-
pear on the OG trunk)
• Y=02 Day Mode
• Y=03 Night Mode
• Y=40 Mode A
• Y=41 Mode B
(1) 000-255: Trunk No.
(2) 04: Direct-In Termination
• Y=04 Day Mode
• Y=05 Night Mode
• Y=42 Mode A
• Y=43 Mode B
(1) 000-255: Trunk No.
(2) CXX
XX: 00-31 (Abbreviated Code for System
• Y=02 IC/BW
(1) 00-63: Trunk Route No.
(2) 1 : Incoming Trunk
3 : Bothway Trunk
• Y=05
Release Signal from Distant Office
(1) 00-63: Trunk Route No.
(2) 0: Not arrive
• Y=09 Incoming Connection Signaling
(1) 00-63: Trunk Route No.
(2) 15 : Ring Down
– 266 –
DIRECT-IN TERMINATION-CCIS
DATA
Speed Dialing Assigned by
CM71>66)
NWA-008853-001 Rev.3.0
97ch3004.fm