NEC NEAX 2000 IPS System Manual page 288

Operating Procedure
To set Do Not Disturb from a Single-Line Telephone or D
1. Lift the handset and receive dial tone.
2. Dial the Do Not Disturb-CCIS feature access code and receive Service Set Tone.
3. Replace the handset.
To cancel Do Not Disturb from a Single-Line Telephone or D
1. Lift the handset and receive dial tone.
2. Dial the Do Not Disturb-CCIS cancellation code and receive Service Set Tone.
3. Replace the handset.
To set Do Not Disturb-CCIS from a D
1. Press the Speaker key and receive dial tone.
2. Press the Do Not Disturb feature key, and the associated LED lights. If the D
an LCD, the display will indicate SET.
3. Press the Speaker key.
To cancel Do Not Disturb-CCIS from a D
1. Press the Speaker key and receive dial tone.
2. Press the Do Not Disturb feature key, and the associated LED goes out. If the D
with an LCD, the display will indicate CNCL.
3. Press the Speaker key.
To do Do Not Disturb Override-CCIS from a D
[Series 3700 R12.1 software required]
1. Lift the handset and receive dial tone.
2. Dial the number of the station set to DND.
3. Receive busy tone, and the LED of Do Not Disturb Override feature key flashes. If the D
equipped with an LCD, the display will indicate DND.
4. Press the Do Not Disturb Override feature key.
5. Receive ring back tone and the station set to DND rings.
NOTE 1: During on Consultation Hold at overriding station, this feature is not available.
NOTE 2: In the case that the station set to DND is talking with another station, the overriding station au-
tomatically join the current conversation to form a three party conference.
CHAPTER 3 SYSTEM DATA PROGRAMMING
term
term
:
term
:
term
:
– 274 –
:
term
:
DO NOT DISTURB-CCIS
term
is equipped with
term
is equipped
term
is
NWA-008853-001 Rev.3.0
97ch3004.fm
JANUARY/31/2006