NEC NEAX 2000 IPS System Manual page 328

• For Satellite Office
START
CM20 Assign the single-digit station number to LCR
Group 3 (A129).
CM8A Assign an area code table to be used to select a
route pattern table.
Assign the same digit which was assigned as
the access code (in CM20) into the selected
area code table.
Assign the next Route Pattern number to the
Route Pattern number assigned CM8A
Y=4005-4007.
NOTE:
Assign the route pattern table with the desired
properties and selection of appropriate routes.
END
Operating Procedure
1. Lift the handset and receive dial tone.
2. Dial the Single-Digit preprogrammed station number.
3. The called station will be rung.
DESCRIPTION
This data is required to expand the
order of LCR selection that is as-
signed by CM8A Y=0000-0255.
The order of LCR selection can be
expand to the maximum seventh.
CHAPTER 3 SYSTEM DATA PROGRAMMING
SINGLE-DIGIT STATION CALLING-CCIS
• Y=0-3 Number Plan Group 0-3
(1) X-XXXX: Access Code
(2) A129: LCR Group 3
• Y=A000
(1) 3
(2) 4005-4007: Area Code Development Pat-
• Y=4005-4007
(1) X-XXXX: Access Code
(2) 0000-0255: Route Pattern No. 000-255
• Y=0000-0255 Route Pattern No. 000-255
(1) 0: Designation of next table
(2) 0000-0255: Next Route Pattern No. 000-
• Y=0000-0255
(1) 1-4: Order of LCR Selection
1: 1st
2: 2nd
3: 3rd
4: 4th
(2) XXX ZZ
XXX: 000-255 (LCR Pattern No.)
ZZ : 00-63 (Trunk Route No.)
– 314 –
DATA
tern No. 5-7
255
NWA-008853-001 Rev.3.0
97ch3005.fm