Calling Name Display-Ccis - NEC NEAX 2000 IPS System Manual

CALLING NAME DISPLAY-CCIS

General Description
This feature permits the station name of a calling or called party at another switching office, through the
CCIS network, to be displayed either on a D
Programming
START
CM08 Provide the system with the Name Display ser-
vice.
Specify the number of digits sent to the CCIS
network to 24 digits.
Specify the time to go back to date and time
display after the call is answered.
Specify the duration to display the name.
Specify the duration of displaying the name
when the incoming call is answered/the select
key for Calling Number Display and Calling
Name Display or CID key is pressed.
[Series 3300 software required]
Specify the duration of displaying the destina-
tion information when the outgoing call is an-
swered by the destination via CCIS.
[Series 3300 software required]
CM20 Assign the access code for station user name
entry from an individual station.
CM35 Assign a trunk name number to each trunk
route.
A
term
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
or an Attendant Console.
(1) 255: Name Display
(2) 1 : To provide
(1) 379: Number of dialed digits
(2) 0: 24 digits
(1) 120
(2) 0 : 10 seconds later
1 : 6 seconds later
(1) 121
(2) 0 : Until call finished
1 : As per CM08>120
(1) 537
(2) 0 : Until call is finished/key is pressed
again
1 : 6 seconds
(1) 538
(2) 0 : Until call is finished
1 : 6 seconds
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code (0-9, *, #)
(2) A110
• Y=03
(1) 00-63: Trunk Route No.
(2) 00-14: Trunk Name No.
15 : Kind of trunk route assigned by
16-63: Trunk Name No.
– 180 –
CALLING NAME DISPLAY-CCIS
DATA
CM35 Y=00 are displayed
NWA-008853-001 Rev.3.0
97ch3002.fm