NEC NEAX 2000 IPS System Manual page 259

To provide an indication on external equipment when Day/Night Mode status is changed by the Attendant
Console at the Main Office, do the following programming.
START
CM10 Assign the DK card to the required LEN.
NOTE 1:
NOTE 2:
CM14 Assign the DK card to the required LEN.
[Series 3200 R6.2 software required]
NOTE 1:
CM44 Assign the function of CCIS Day/Night status
Indication to the DK card.
END
DESCRIPTION
We recommend the setting of DK
card number by CM14, when using
Series 3200 R6.2 software or later.
The DK card number must be as-
signed to the 1st LEN (Level 0) and
the 3rd LEN (Level 2) of each LT
slot.
The DK card number must be as-
signed to the 1st LEN (Level 0) and
the 3rd LEN (Level 2) of each LT
slot.
CHAPTER 3 SYSTEM DATA PROGRAMMING
CENTRALIZED DAY/NIGHT MODE CHANGE-CCIS
(1) 000-763: LEN
(2) E800-E831: DK Card No.
For PIM0/PIM1: E800-E807
For PIM2/PIM3: E808-E815
For PIM4/PIM5: E816-E823
For PIM6/PIM7: E824-E831
NOTE 3:
(1) XX ZZZ (LEN)
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
(2) E800-E831: DK Card No.
NONE : No data
For FP No.00: E800-E807
For FP No.01: E808-E815
For FP No.02: E816-E823
For FP No.03: E824-E831
NOTE 2:
(1) XX Y: Circuit No.
XX: 00-31: DK Card No. assigned by
Y : 0-3: Circuit No.
313: Built-in External Equipment Interface
on MP card
(2) 3601
– 245 –
DATA
Circuit No. 3 of E831 is used for
built-in External Equipment In-
terface of MP card by setting
CM44.
Circuit No.03 of E831 is used for
built-in External Equipment In-
terface of MP card by setting
CM44.
CM10/CM14 E800-E831
NWA-008853-001 Rev.3.0
97ch3004.fm