NEC NEAX 2000 IPS System Manual page 316

Programming
START
CM10 Assign a network station number to the re-
quired LEN.
NOTE:
CM14 Assign a network station number to the re-
quired LEN.
[Series 3200 R6.2 software required]
CM20 Assign the Access Code for the number of dig-
its of the network station number.
CM8A Assign the Area Code Development Pattern
number for LCR Group.
Assign the Route Pattern number to each area
code for the Area Code Development Pattern
number assigned by CM8A Y=A000.
Assign the next Route Pattern number to the
Route Pattern number assigned by CM8A
Y=4005-4007.
NOTE:
A
DESCRIPTION
We recommend the setting of net-
work station number by CM14,
when using Series 3200 R6.2 soft-
ware or later.
This data is required to expand the
order of LCR selection that is as-
signed by CM8A Y=0000-0255.
The order of LCR selection can be
expand to the maximum seventh.
CHAPTER 3 SYSTEM DATA PROGRAMMING
NETWORK STATION NUMBER-CCIS (FCCS)
(1) 000-763: LEN
(2) X-XXXXXXXX: Network station No.
(1) XX ZZZ (LEN)
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
(2) X-XXXXXXXX: Network station No.
NONE : No data
• Y=0-3: Numbering Plan Group 0-3
(1) X-XXXX: Access Code
(2) 811-818: 1-8 digits network station No.
• Y=A000
(1) 0-3: LCR Group No. 0-3
(2) 4005-4007: Area Code Development Pat-
• Y=4005-4007: Area Code Development
(1) X-XXXXXXXX: Area Code
(2) 0000-0255: Route Pattern No. 000-255
• Y=0000-0255 Route Pattern No.000-255
(1) 0: Designation of next table
(2) 0000-0255: Next Route Pattern No.000-
– 302 –
DATA
tern No. 5-7
Pattern No. 5-7
255
NWA-008853-001 Rev.3.0
97ch3005.fm