How To Read This Chapter - NEC NEAX 2000 IPS Manual
Internet protocol server wcs system manual (phs) (for series 3300 or later)
Hide thumbs
Also See for NEAX 2000 IPS:
- Command manual (1038 pages) ,
- Installation manual (619 pages) ,
- System manual (448 pages)
Table of Contents
Advertisement
HOW TO READ THIS CHAPTER
In the programming procedure, the meanings of (1), (2) and markings are as follows.
(1)
: 1st Data
(2)
: 2nd Data
: Initial Data
With the system data clear command (CM00, CM01), the data with this marking is auto-
matically assigned for each command.
INITIAL
: A reset of the MP card is required after data setting.
CSH INITIAL
: A reset of the CSH card is required after data setting.
OFF LINE
: Command with this marking can be used only under Off-Line mode of the MP card.
For general description, operating procedure, service conditions of WCS features, refer to APPENDIX:
WCS FEATURES AND SPECIFICATIONS.
Press SW1 switch on the MP card.
Set the Make Busy switch to Up and then Down.
To set Off-Line mode,
(1) Set SW3 on the MP card to "2" or "3".
(2) Press SW1 on the MP card.
CHAPTER 3 SYSTEM DATA PROGRAMMING
– 86 –
HOW TO READ THIS CHAPTER
NWA-008855-001 Rev.1.0
avch3001.fm
Advertisement
Table of Contents
