NEC NEAX 2000 IPS System Manual page 361

Operating Procedure
To record and stop one's own conversation into the VMS:
1. Push the function key assigned by CM90 Y=00: F5026 during conversation. If your station con-
nects to the VMS, then start recording. If not, the recording function is not available.
2. To stop recording, push the function key assigned by CM90 Y=00: F5026 (CM08>578: 0 is set) or
CM90 Y=00: F5027 (CM08>578: 1 is set) or release the line, and the recording automatically
stops.
3. After you stop recording, D
NOTE 1: While recording, the operations such as hooking/holding is not available at both sides.
NOTE 2: Though the opposite side releases the line, the recording continues as long as the recording side
doesn't stop recording.
To play a record from the VMS:
There are two ways to play it.
One way is the same as
Page 342
The other way is as follows.
1. Lift the handset and receive dial tone.
2. Push the function key assigned by CM90 Y=00, then you can hear the record from the VMS.
To clear a record from the VMS:
To forward a record to another station in the VMS:
1. Lift the handset and receive dial tone.
2. Dial the voice station number and receive ringback tone.
The LCD shows:
[ xxx]
VMS: Voice mail station number
3. Follow the instructions given by the VMS.
term
returns to the normal status.
VOICE MAIL INTEGRATION-CCIS. See that of Operating Procedure.
CHAPTER 3 SYSTEM DATA PROGRAMMING
– 347 –
VOICE MAIL LIVE RECORD-CCIS
NWA-008853-001 Rev.3.0
97ch3005.fm
JANUARY/31/2006