NEC NEAX 2000 IPS System Manual page 205

AP Initialization (PN-AP00-B with AP00 program)
This section explains the data assignment to make the AP active. If the system already applied the AP re-
lated feature, you can skip the data assignment explained on this section. The AP should have already ac-
tivated if one of the following feature applied; Station Message Detail Recording (SMDR), Message
Center Interface (MCI), D
System (PMS), or Hotel printer. You can distinguish whether the AP active or not by the RUN lamp indi-
cation. The RUN lamp flashes on green color when the AP is in active.
When installing the AP00 at first time, do the following AP initialization.
START
CM05 Assign an AP number to the AP00 card.
The AP number must match the SENSE switch
setting on the AP00 card.
On the AP00 card, set SW1 switch as shown
below.
SW1
ON
CMD101 Load the initial data into the AP00 card.
CMD001 Specify Local Office or Center Office for Cen-
tralized Billing-CCIS
A
term
TIMS (Time Information Management System), Property Management
DESCRIPTION
4
3
: POSITION TO BE SET
2
1
AP OFF LINE
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=0
(1) 04-15, 20-31: AP No.
(2) 04: AP00 card
INITIAL
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
(1) 0000
(2) CCC
(1) 179
(2) 0 : Local Office
1 : Center Office
– 191 –
CENTRALIZED BILLING-CCIS
DATA
NWA-008853-001 Rev.3.0
97ch3003.fm
JULY/01/2006