Paging Access-Ccis - NEC NEAX 2000 IPS System Manual

PAGING ACCESS-CCIS

General Description
This feature provides dial access to paging equipment from an Attendant Console or station, through the
CCIS network.
Programming
START
CM10 Assign the Paging Trunk (COT card and DK
card) to the required LEN.
NOTE 1:
NOTE 2:
CM14 Assign the Paging Trunk (COT card and DK
card) to the required LEN.
[Series 3200 R6.2 software required]
NOTE 1:
A
DESCRIPTION
We recommend the setting of COT/
DK card number by CM14, when us-
ing Series 3200 R6.2 software or
later.
The DK card number must be as-
signed to the first LEN (Level 0) and
the third LEN (Level 2) of each LT
slot.
The DK card number must be as-
signed to the 1st LEN (Level 0) and
the third LEN (Level 2) of each LT
slot.
CHAPTER 3 SYSTEM DATA PROGRAMMING
(1) 000-763: LEN
(2) D000-D254: COT card
E800-E831 : DK Card
For PIM0/1: E800-E807
For PIM2/3: E808-E815
For PIM4/5: E816-E823
For PIM6/7: E824-E831
NOTE 3:
(1) XX ZZZ (LEN)
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
(2) D000-D254
E800-E831 : DK Card No.
NONE : No data
For FP No.00: E800-E807
For FP No.01: E808-E815
For FP No.02: E816-E823
For FP No.03: E824-E831
NOTE 2:
– 309 –
PAGING ACCESS-CCIS
DATA
Circuit No. 3 of E831 is used for
built-in External Equipment In-
terface on the MP card by setting
CM44.
Circuit No.03 of E831 is used for
built-in External Equipment In-
terface of MP card by setting
CM44.
NWA-008853-001 Rev.3.0
97ch3005.fm