Ldt/Odt Assignment - NEC NEAX 2000 IPS System Manual

LDT/ODT Assignment

START
CM10 Assign a trunk number to each LDT/ODT
card.
NOTE 1:
NOTE 2:
CM14 Assign a trunk number to each LDT/ODT
card.
[Series 3200 R6.2 software required]
NOTE:
CM30 Assign a trunk route number to each trunk.
A
DESCRIPTION
We recommend the setting of trunk
number by CM14, when using Series
3200 R6.2 software or later.
The Trunk number must be assigned
to the 1st LEN (Level 0) and the 2nd
LEN (Level 1) of each LT slot.
The Trunk number must be assigned
to the 1st LEN (Level 0) and the 2nd
LEN (Level 1) of each LT slot.
CHAPTER 3 SYSTEM DATA PROGRAMMING
(1) 000-763: LEN
(2) D000-D254: Trunk No.
Any trunk number already assigned by
CM07 cannot be used.
Do not assign Trunk No.D255 for CCIS.
(1) XX ZZZ (LEN)
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
(2) DD000-DD254: Trunk No.
NONE : No data
Any trunk number already assigned by
CM07 cannot be used.
Do not assign Trunk No.255 for CCIS.
• Y=00
(1) 000-254: Trunk No. assigned by CM10/
(2) 00-63: Trunk Route No.
– 129 –
ANALOG CCIS PROGRAMMING
DATA
CM14
NWA-008853-001 Rev.3.0
97ch3001.fm