NEC NEAX 2000 IPS System Manual page 209

AP Initialization (PN-AP00-B/PN-AP00-D with MRCA program)
[Series 3300 software required]
This section explains the data assignment to make the AP active. If the system already applied the AP re-
lated feature, you can skip the data assignment explained on this section. The AP should have already ac-
tivated if one of the following feature applied; Station Message Detail Recording (SMDR), Message
Center Interface (MCI), D
Disturb set/cancel at specified timing in advance. You can distinguish whether the AP active or not by the
RUN lamp indication. The RUN lamp flashes on green color when the AP is in active.
When installing the AP00 at first time, do the following AP initialization.
START
CM05 Assign an AP number to the AP00 card.
The AP number must match the SENSE switch
setting on the AP00 card.
On the AP00 card, set the SW1 switch as
shown below.
SW1
ON
CMDD99 Load the initial data into the AP00 card.
On the AP00 card, set the SW1 switch as
shown below.
SW 1
ON
A
term
TIMS (Time Information Management System), Hotel printer, or Do Not
DESCRIPTION
4
3
: POSITION TO BE SET
2
1
AP OFF LINE
4
3
: POSITION TO BE SET
2
1
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=0
(1) 04-15, 20-31: AP No.
(2) 45: AP00 with MRCA program
INITIAL
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
(1) 0000
(2) CCC
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
– 195 –
CENTRALIZED BILLING-CCIS
DATA
NWA-008853-001 Rev.3.0
97ch3003.fm
JULY/01/2006